Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
Notice: Refer to Vehicle Lifting and Jacking Notice in the Preface section.
- Raise and suitably support the vehicle.
- Disconnect the electrical connector from the front wheel speed sensor.
- Remove the bolt and the front wheel speed sensor from the steering knuckle.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the bolt and front wheel speed sensor to the steering knuckle.
Tighten
Tighten the bolt to 9 N·m (7 lb ft).
- Connect the electrical connector to the front wheel speed sensor.
- Lower the vehicle.
- Connect the negative battery cable.