Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Disconnect the vacuum hose from the manifold absolute pressure (MAP) sensor.
- Disconnect the MAP connector.
- Remove the MAP sensor mounting bracket bolt.
- Remove the bolts and nuts securing the MAP sensor to the mounting bracket.
Installation Procedure
- Insert the MAP sensor into the mounting bracket.
Notice: Refer to Fastener Notice in the Preface section.
- Install the bolts through the MAP sensor and the bracket. Install the retaining nuts.
Tighten
Tighten the MAP sensor retaining bolts and nuts to 8 N·m (71 lb in).
- Install the MAP sensor and the mounting bracket to the firewall with the mounting bracket bolt.
Tighten
Tighten the MAP sensor mounting bracket bolt to 4 N·m (35 lb in).
- Connect the MAP sensor connector.
- Connect the vacuum hose to the MAP sensor.
- Connect the negative battery cable.