Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
Notice: Refer to Vehicle Lifting and Jacking Notice in the Preface section.
- Raise and suitably support the vehicle.
- Disconnect the electrical connector for the rear wheel speed sensor from
the rear axle.
- Remove the mounting bolt from the rear wheel speed sensor.
- Remove the cable grommets from the rear wheel speed sensor, and remove
the speed sensor.
Installation Procedure
- Install the rear wheel speed sensor, and install the cable grommets.
Notice: Refer to Fastener Notice in the Preface section.
- Install the rear wheel sensor mounting bolt.
Tighten
Tighten the bolt to 9 N·m (7 lb ft).
- Connect the electrical connector for the rear wheel speed sensor to the
rear axle.
- Lower the vehicle.
- Connect the negative battery cable.