Tools Required
KM-210-A Steering Wheel
Puller
J 36541-A Steering Wheel
Puller Legs
J 1859-A Steering Wheel Puller
Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Remove the SIR module. Refer to
Disabling the SIR System
in SIR.
- Remove the steering wheel nut and the retaining clip.
- Remove the steering wheel using the KM-210-A
or J 1859-A
withJ 36541-A
.
- Unclip the contact ring from the steering wheel, if necessary.
Installation Procedure
- Clip the contact ring on the steering wheel, if necessary.
Important: In order to install the steering wheel correctly,
match-mark the steering column shaft to the steering wheel.
- Align the match marks on the steering wheel and the steering column shaft. Turn
the signal-canceling cam on the wheel to the left.
Notice: Refer to Fastener Notice in the Preface section.
- Install the retaining clip and the steering wheel nut.
Tighten
Tighten the steering wheel nut to 38 N·m
(28 lb ft).
- Bend the tabs to secure the retaining clip.
- Install the SIR module. Refer to
Disabling the SIR System
in SIR.
- Connect the negative battery cable.