Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Remove the trim panel screws.
- Remove the trim panel.
- Turn the stop lamp switch and the connector assembly, and pull it from the brake pedal bracket.
- Separate the stop lamp switch from the connector to replace the stop lamp switch.
Installation Procedure
- Install the connector to the stop lamp switch.
- Turn the stop lamp switch and the connector assembly, and twist it into the brake pedal bracket.
- Press the brake pedal and pull the switch plunger to its maximum setting to adjust the switch.
- Release the plunger and pull up on the pedal.
Notice: Refer to Fastener Notice in the Preface section.
- Install the trim panel screws.
Tighten
Tighten the trim panel screws to 7 N·m (62 lb in).
- Connect the negative battery cable.