Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Remove the intake manifold bracket bolts and bracket.
- Disconnect the knock sensor (KS) electrical connector.
- Remove the Knock sensor bolt.
- Remove the knock sensor.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the KS with the bolt.
Tighten
Tighten the KS bolt to 20 N·m (15 lb ft).
- Connect the KS electrical connector.
- Install the intake manifold bracket and bolts.
Tighten
• | Tighten the bracket upper bolt to 25 N·m (18 lb ft). |
• | Tighten the bracket lower bolt to 45 N·m (33 lb ft). |
- Connect the negative battery cable.