Diagnostic Instructions
DTC Descriptor
DTC P050B: Ignition Timing Performance
Circuit/System Description
The engine control module (ECM) continuously compares the commanded spark timing to the actual spark timing. The ECM uses the crankshaft position (CKP) sensor and the camshaft position (CMP) sensor in order to calculate the actual spark timing.
Conditions for Running the DTC
• | DTCs P0300, P0301, P0302, P0303, P0304, P0335, P0336, P0351, P0352, P0353, and P0354 are not set. |
• | The engine speed is steady. |
• | The ignition voltage is between 11-16 volts. |
• | The DTC runs continuously once the above conditions are met. |
Conditions for Setting the DTC
• | The ECM detects the difference between the actual spark and the commanded spark is greater than 5 degrees. |
• | The condition exists for more than 7 seconds. |
Action Taken When the DTC Sets
DTC P050B is a Type B DTC.
Conditions for Clearing the DTC
DTC P050B is a Type B DTC.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Circuit/System Testing
- Engine running, observe the DTC information with a scan tool. Verify that DTC P0016, P0324, P0325, or P0340 is not set.
- Observe the DTC information with a scan tool. DTC P050B should not set.
⇒ | If P050B is set, replace the ECM. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ECM replacement, setup, and programming