Removal Procedure
Notice: Do not allow the fuel pressure to exceed the specified value because
damage to the fuel pressure regulator or the fuel pressure gage
may result.
- Relieve the fuel system pressure. Refer to
Fuel Pressure Relief
.
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Remove the rear seat.
- Remove the fuel pump access cover.
- Disconnect the electrical connector at the fuel pump assembly.
- Disconnect the fuel outlet line.
- Turn the lock ring counterclockwise to clear the tank tabs.
- Remove the fuel pump assembly from the tank.
- Remove and discard the gasket.
Installation Procedure
- Clean the gasket mating surface on the fuel tank.
- Position the new gasket in place.
- Install the fuel pump into the fuel tank in the same location as removed for ease of line and connector installation.
- Position the lock ring in place and turn it clockwise until it contacts the tank stop.
- Connect the fuel pump assembly connector.
- Install the fuel pump outlet line.
- Install the pump access cover.
- Connect the negative battery cable.
- Perform an operational check of the fuel pump.
- Install the rear seat.