GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Aveo 🢒 Transmission/Transaxle 🢒 Shift Lock Control 🢒 Shift Lock Control Solenoid Replacement

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1245816 Size: SH
  1. Disconnect the negative battery cable.
  2. Remove the floor console. Refer to Front Floor Console Replacement .
  3. Disconnect the wiring harness connectors from the shift control lever.

    4. Object Number: 1245812 Size: SH
  4. Loosen the control cable adjusting nut.
  5. Disconnect the control cable from the shift control lever assembly.

    6. Object Number: 1889696 Size: SH
  6. Remove the shift control lever assembly mounting bolts.
  7. Remove the shift control lever assembly.

    8. Object Number: 1872311 Size: SH
  8. Remove the two shift lever control knob retaining screws, the then knob from the assembly.
  9. Carefully remove the shift select cover from the lever assembly.

    10. Object Number: 1872313 Size: SH
  10. Remove the shift lock solenoid retaining screws.
  11. Remove the solenoid from the assembly.

Installation Procedure
  1. Install the shift lock solenoid on the assembly.

    2. Object Number: 1872313 Size: SH
  2. Install the shift lock solenoid retaining screws.
  3. Carefully install the shift select cover to the lever assembly.

    4. Object Number: 1872311 Size: SH
  4. Install the shift lever control knob, then the retaining screws.

    5. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1889696 Size: SH
  5. Install the shift control lever assembly and mounting bolts.

    6. Tighten
    Tighten the shift control lever assembly mounting bolts to 8 N·m (71 lb in).


    Object Number: 1245812 Size: SH
  6. Connect the control cable to the shift control lever assembly.
  7. Tighten the control cable adjusting nut.

    8. Tighten
    Tighten the control cable adjusting nut to 8 N·m (71 lb in).


    Object Number: 1245816 Size: SH
  8. Connect the harness connector.
  9. Adjust the control cable. Refer to Range Selector Lever Cable Adjustment .
  10. Install the floor console. Refer to Front Floor Console Replacement .
  11. Connect the negative battery cable.