GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Aveo 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Ignition Lock Cylinder Replacement

Removal Procedure
  1. Disconnect the negative battery cable.

    2. Object Number: 1715979 Size: SH
  2. Remove the screws (6, 7, 8) and the lower steering column cover panel (5).

    3. Object Number: 1716043 Size: SH
  3. Complete the following steps in order to remove the key reminder switch (3):
    4. 3.1. Remove the steering wheel. Refer to Steering Wheel Replacement .
    3.2. Remove the screws (1,2).
    3.3. Remove the key reminder switch.
    3.4. Disconnect the key reminder switch connector.

    Object Number: 1716019 Size: SH
  4. Complete the following steps in order to remove the ignition lock cylinder (2):
    5. 4.1. Turn the key to the ACC position.
    4.2. Use a 2.5 allen wrench, or equivalent, in order to press the detent spring in the ignition lock cylinder.
    4.3. Remove the ignition lock cylinder.

    Object Number: 1716033 Size: SH
  5. Complete the following steps in order to remove the ignition switch (2):
    6. 5.1. Remove the ignition switch screw (1).
    5.2. Remove the ignition switch.
    5.3. Disconnect the ignition switch connector.

    Object Number: 1716070 Size: SH
  6. Complete the following steps in order to remove the key hole illumination (1):
    7. 6.1. Remove the key hole illumination screw (2).
    6.2. Remove the key hole illumination.
    6.3. Disconnect the key hole illumination connector.

Installation Procedure

    Object Number: 1716070 Size: SH
  1. Complete the following steps in order to install the key hole illumination (1):
    2. 1.1. Install the key hole illumination.
    1.2. Install the key hole illumination screw (2).
    1.3. Connect the key hole illumination connector.

    Object Number: 1716033 Size: SH
  2. Complete the following steps in order to install the ignition switch (2):
    3. 2.1. Install the ignition switch.
    2.2. Install the ignition switch screw (1).
    2.3. Connect the ignition switch connector.

    Object Number: 1716019 Size: SH
  3. Install the ignition lock cylinder (2).
  4. Remove the key.

    5. Object Number: 1716043 Size: SH
  5. Complete the following steps in order to install the key reminder switch (3):
    6. 5.1. Install the key reminder switch.
    5.2. Install the screws (1,2).
    5.3. Connect the key reminder switch connector.
    5.4. Install the steering wheel. Refer to Steering Wheel Replacement .

    Object Number: 1715979 Size: SH
  6. Install the lower steering column cover panel (5) and the screws (6, 7, 8).
  7. Connect the negative battery cable.