Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Remove the audio system trim molding.
- Remove the lower HVAC control assembly trim molding.
- Remove the HVAC control assembly screws.
- Disconnect the electrical connectors.
- Remove the HVAC control assembly.
Installation Procedure
- Connect the electrical connectors.
Notice: Refer to Fastener Notice in the Preface section.
- Position the HVAC control assembly on the center molding and install the retaining screws.
Tighten
Tighten the control assembly retaining screws to 2 N·m (18 lb in).
- Install the audio trim panel.
- Connect the negative battery cable.