Inspection Procedure
Warning: Refer to Safety Glasses Warning in the Preface section.
- Inspect valve stem tip wear.
- Inspect the valve keeper grooves and oil seal grooves for chips and wear.
- Inspect the valves for burns or cracks.
- Inspect the valve stem for burrs and scratches.
- Inspect the valve stem. The valve stem must be straight.
- Inspect the valve face for grooving. If the groove is so deep the refacing would result in a sharp edge, replace the valve.
- Inspect the valve spring. If the valve spring ends are not parallel, replace the valve spring.
- Measure the valve spring height. Refer to
Engine Mechanical Specifications. If the valve spring height does not match the specifications, replace the valve spring.
Cleaning Procedure
Warning: Refer to Safety Glasses Warning in the Preface section.
- Clean the cylinder head.
- Clean the valve guides.
- Clean all of the threaded holes.
- Clean the valves of carbon, oil, and varnish.