For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit/System Description
Battery voltage is supplied to the antilock brake system (ABS) warning lamp with the ignition switch in the ON or START position. The warning lamp should be activated only by the ABS control module internally supplying ground to terminal 10.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Verify EBCM connector is secure.
| ⇒ | If EBCM connector is not secure, repair EBCM connection |
Circuit/System Testing
- Ignition OFF, disconnect the EBCM connector.
- Release the shorting bar from terminal 10 and test for infinite resistance between terminal 10 of the EBCM connector and ground.
| ⇒ | If resistance in not as specified, repair the circuit for a short to ground. If the circuit tests normal, replace the BPMV/EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup, and programming
