For 1990-2009 cars only
Removal Procedure
- Remove the air hose between the air cleaner and throttle body.
- Remove the battery from the vehicle.
- Remove the transaxle side select and shift control cable pins (1) and the washers (2).
- Disconnect the select and shift control cable (3).
- Remove the cable E-rings (4).
- Disconnect the cables from the cable bracket.
- Remove the floor console. Refer to Front Floor Console Replacement.
- Move the floor carpet to gain access to the gear shift cable.
- Remove the gear shift lever side select and shift control cable U-clip.
- Remove the eye ring.
- Remove the select control cable E-ring.
- Disconnect the select control cable.
- Remove the shift control cable pin and cable E-ring.
- Remove the shift control cable.
- Remove the select and shift control cable nuts and pull the cables out in the passenger room.
Warning: Refer to Batteries Produce Explosive Gases Warning in the Preface section.
Installation Procedure
- Install the cables toward the engine compartment through the dash panel.
- Position the cables on the select and the shift lever.
- Connect the transaxle side select and shift control cables (4).
- Connect the gear shift lever side shift control cable.
- Insert the gear shift select control cable eye ring to the select arm pin.
- Install the gear shift selector lever control cable clip.
- Install the gear shift select control cable to the gear shift lever bracket with the E-ring.
- Insert a screwdriver to the select arm adjustment hole to prevent the movement of the gear shift lever in NEUTRAL.
- Connect the gear shift lever side select control cable.
- Install the floor console. Refer to Front Floor Console Replacement.
- Install the gear cable adjust nut and tighten to 10 N·m (89 lb in).
- Install the battery.
- Install the air hose to the air cleaner and throttle body.
Caution: Refer to Fastener Caution in the Preface section.
