Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the negative battery cable.
- Remove the audio system trim molding.
- Remove the lower HVAC control assembly trim molding.
- Remove the HVAC control assembly screws.
- Disconnect the electrical connectors.
- Remove the HVAC control assembly.
Installation Procedure
- Connect the electrical connectors.
Caution: Refer to Fastener Caution in the Preface section.
- Position the HVAC control assembly on the center molding and install the retaining screws and tighten to
2 N·m (18 lb in).
- Install the audio trim panel.
- Connect the negative battery cable.