• | Perform the Diagnostic System Check - Vehicle prior to using the diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
When the ignition switch is turned to ON, the sensing and diagnostic module (SDM) will perform a turn-on test to diagnose critical malfunctions within SDM itself.
Upon passing these tests, ignition and deployment loop voltages are measured to ensure that they are within their normal voltage ranges. The SDM monitors the voltages at the driver low and the passenger low to detect shorts to ground or voltage in the deployment loops.
Ignition voltage is between 9-16 volts.
The voltage supplied from the battery is over 16.5 volts.
The SDM commands the air bag indicator ON.
The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
Note: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
• The SDM module • The SDM wiring harness connector
Test the charging system for proper operation.
⇒ | If charging system test normal, replace the SDM. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for BCM and SDM replacement, setup, and programming