For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using the diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC C1395: Fill and Bleed Not CompleteCircuit/System Description
This procedure checks whether the brake system has been filled and bled properly.
Conditions for Running the DTC
| • | Vehicle speed is greater than 6 km/h (4 mph) with the brake pedal not applied. |
| OR |
| • | Vehicle speed is greater than 15 km/h (9 mph) and the brake pedal is actuated. |
Conditions for Setting the DTC
| • | Improper battery voltage |
| • | Brake system not properly bled |
Action Taken When the DTC Sets
| • | The antilock brake system (ABS) is disabled. |
| • | The ABS warning indicator turns ON. |
| • | The electronic brake force distribution (EBD) is disabled. |
Conditions for Clearing the DTC
The condition for setting the DTC is no longer present and the DTC is cleared with a scan tool.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Electrical Information Reference
Scan Tool Reference
Electronic Brake Control Module Scan Tool Information
Circuit/System Testing
- Measure for 10-16 V across the battery terminals.
- If voltage is as specified, bleed the brake system.
| ⇒ | If voltage is not as specified, check battery and charging system. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM and BPMV replacement, setup, and programming
