Stabilizer Shaft Link Replacement RWD

1. Raise and suitably support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the to the stabilizer shaft link retaining nut.
4. Remove the retainers from the stabilizer shaft link bolt.
5. Remove the grommets from the stabilizer shaft link bolt.
6. Remove the following parts from the stabilizer shaft link bolt:

6.1.	The grommet

6.2.	The retainer

6.3.	The spacer

6.4.	The retainer

6.5.	The grommet

1. Install the retainers and the grommets to the stabilizer shaft link bolt. Position the parts correctly.
2. Install the stabilizer shaft link bolt through the lower control arm hole. Stack the parts in the following order:

2.1.	The grommet

2.2.	The retainer

2.3.	The spacer

2.4.	The retainer

2.5.	The grommet

3. Install the stabilizer shaft link bolt through the upper control arm hole.
4. Install the grommets to the stabilizer shaft link bolt.
5. Install the retainers to the stabilizer shaft link bolt.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the to the stabilizer shaft link retaining nut to the stabilizer shaft link bolt until the nut meet the end of the bolt threads.

Tighten
Tighten the stabilizer shaft link retaining nut to 18 N·m (13 lb ft).

7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
8. Lower the vehicle.

Stabilizer Shaft Link Replacement 4WD

1. Raise and suitably support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the stabilizer shaft link bolt.
3. Remove the stabilizer shaft link insulator, spacer, and upper retainer.
4. Inspect all of the parts for wear or damage.

1. Install the stabilizer shaft link insulators to the stabilizer shaft link bolt.
2. Install the stabilizer shaft link bolt through the stabilizer shaft.
3. Install the stabilizer shaft link spacer.
4. Install the stabilizer shaft link bolt through the lower control arm with the parts stacked properly.
5. Install the stabilizer shaft link upper retainer.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Tighten the stabilizer shaft link bolt.

Tighten
Tighten the stabilizer shaft link bolt to 15 N·m (11 lb ft).

7. Lower the vehicle.