Tie Rod Replacement ZR2 Models

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Support the rear axle at a curb height position.



3. Remove the following parts from the frame bracket:

•	The rear tie rod mounting bolt

•	The washers

•	The rear tie rod mounting nut




4. Remove the following parts from the axle bracket:

•	The rear tie rod mounting bolt

•	The washers

•	The rear tie rod mounting nut




5. Remove the rear tie rod.

1. Position the rear tie rod in the frame bracket.



2. Loosely install the following parts to the axle bracket:

•

The bolt

•	The washers

•

The nut




3. Position the rear tie rod in the axle bracket.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Loosely install the following parts to the frame bracket:

•

The bolt

•	The washers

•

The nut

Tighten

•	Tighten the rear tie rod to axle bracket nut to 61 N·m (45 lb ft).

•	Tighten the tie rod to the frame bracket nut to 61 N·m (45 lb ft).

5. Remove the rear axle support.
6. Lower the vehicle.