Tools Required
• | J 8092 Universal Driver
Handle - ¾ in - 10 |
Removal Procedure
- Remove the differential assembly. Refer to
Differential Replacement
.
- Remove the differential side bearings by doing the following:
2.1. | Install the differential assembly into a vise. |
2.2. | Install the J 8107-2
(7.6 inch axle and 1st design 8.6 inch axle) or the J 8107-4
(2nd design 8.6 inch axle) (1) J 22888-20A
(2) onto the differential
case. |
2.3. | Remove the differential side bearings using the J 22888-20A
. |
- Remove the differential assembly from the vise.
Installation Procedure
- Install
the differential side bearings by doing the following:
1.1. | In order to protect the differential case, install the J 8107-2
or the J 8107-4
in the case on the side opposite the bearing installation. |
1.2. | Install the J 25299
(7.6 inch axle and 1st design 8.6 inch axle) or theJ 21784
(2nd design 8.6 inch axle) (2)
and the J 8092
(1) onto
the differential case bearing as shown. |
- Install the differential assembly. Refer to
Differential Replacement
.