Removal Procedure
- Remove the center console from the vehicle if equipped with RPO code
YC7 (GMC Envoy). Refer to
Front Floor Console Replacement
.
- Remove the screws that retain the instrument panel sound insulator
to the following components:
- Remove the instrument panel sound insulator from the vehicle.
- Disconnect the electrical connector from the accessory power outlet,
if equipped.
Installation Procedure
- Connect the electrical connector to the accessory power outlet,
if equipped.
- Install the instrument panel sound insulator to the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the screws
that retain the instrument panel sound insulator to the following components:
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
- Install the screw that retains the instrument panel sound insulator
to the heater assembly.
Tighten
Tighten the screw to 1.5 N·m (13 lb in).
- Install the center console to the vehicle if equipped with RPO
code YC7 (GMC Envoy). Refer to
Front Floor Console Replacement
.
