GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Blazer - 2WD 🢒 Transmission/Transaxle 🢒 Manual Transmission - NV 1500 🢒 Control Lever and/or Boot Replacement

Removal Procedure

    Object Number: 392695 Size: SH
  1. If equipped remove the 3 console nuts and the console.
  2. Remove the shift lever from the shift tower. Do not remove the shift lever adjusting nut.

    3. Object Number: 392696 Size: SH
  3. Pull back the carpet to access the screws.
  4. Remove the screws securing the boot to the panel.

Installation Procedure

    Object Number: 392696 Size: SH
  1. Install the boot over the shift tower.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the shift boot screws.

    3. Tighten
    Tighten the screws to 2 N·m (18 lb in).


    Object Number: 392695 Size: SH
  3. Install the shift lever to the shift tower. If required, center the shift lever with the adjusting nut.

    4. Tighten
    Tighten the adjusting nut to 48 N·m (35 lb ft).

  4. If equipped Install the console and the 3 console nuts.

    5. Tighten
    Tighten the nuts to 2 N·m (18 lb in).