Schematic Reference: Wiper/Washer Schematics

Connector End View Reference: Wiper/Washer Connector End Views

Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Wiper/Washer Systems

1. Turn the ignition ON.
2. Turn the windshield wiper/washer switch OFF.

Do the windshield wipers remain in the park position?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Turn the ignition OFF.
2. Disconnect the inline harness connector C211.
3. Remove the connector terminal row E from the steering column harness connector half.
4. Connect the inline harness connector C211.
5. Turn the ignition ON.

Are the windshield wipers always on?

Go to Step 4

Go to Step 5

Test the windshield wiper switch signal 2 circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 7

Go to Step 6

Replace the windshield wiper/washer switch. Refer to Turn Signal Multifunction Switch Replacement .

Is the repair complete?

Go to Step 7

--

Replace the windshield wiper motor module. Refer to Windshield Wiper System Module Replacement in Steering Wheel and Column.

Is the repair complete?

Go to Step 7

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3