• | The DIC displays SC when there is a shorted condition within the system. |
• | For intermittent diagnosis, refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems. |
• | Refer to Ambient Air Temperature Sensor Resistance in order to verify the correct ambient temperature sensor readings. |
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Driver Information System Schematics Connector End View Reference: Instrument Panel, Gages, and Console Connector End Views | |||
1 | Did you perform the Driver Information Systems Diagnostic System Check? | Go to Step 2 | |
2 |
Important: Verify the J 33431-C resistance settings with a DMM. Disconnect one of the J 33431-C leads momentarily between the resistance settings in order to quickly update the DIC display.Does the DIC display the correct temperature? | Go to Step 4 | Go to Step 3 |
3 | Test the signal circuit of the ambient temperature sensor for a short to ground. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 7 | Go to Step 6 |
4 | Inspect for a poor connection at the harness connector of the ambient temperature sensor. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 7 | Go to Step 5 |
5 | Replace the ambient temperature sensor. Refer to Ambient Air Temperature Gage Sensor Replacement . Did you complete the replacement? | Go to Step 7 | -- |
6 |
Important: Perform the compass calibration and variance procedure on the replacement DIC. Replace the DIC. Refer to Driver Information Center Module Replacement . Did you complete the replacement? | Go to Step 7 | -- |
7 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |