Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Body Rear End Schematics | |||
1 | Did you perform A Body Rear End Diagnostic System Check? | Go to Step 2 | |
2 | Close the liftgate or liftglass. Is the tail gate alarm indicator illuminated? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
3 |
Does the scan tool display active? | Go to Step 10 | Go to Step 4 |
4 | Disconnect the liftgate ajar jamb switch. Does the scan tool display inactive? | Go to Step 6 | Go to Step 5 |
5 | Test the liftgate ajar jamb switch signal circuit for a short to battery positive. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 7 |
6 | Inspect for poor connections at the harness connector of the liftgate ajar jamb switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 8 |
7 | Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 9 |
8 | Replace the liftgate ajar jamb switch. Did you complete the replacement? | Go to Step 11 | Go to Step 11 |
9 |
Important: When replacing the body control module (BCM), refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System. Replace the BCM. Refer to Body Control Module Replacement in Body Control System. Did you complete the replacement? | Go to Step 11 | -- |
10 | Replace the instrument panel cluster. Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console. Did you complete the repair? | Go to Step 11 | -- |
11 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
