GM Service Manual Online
For 1990-2009 cars only

Rear Side Door Trim Panel Replacement Utility

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

Removal Procedure

  1. Remove the window weatherstrip. Refer to Rear Side Door Window Weatherstrip Replacement .
  2. Remove the door handle bezel. Refer to Door Inside Handle Bezel Replacement .
  3. Remove the window regulator handle, if equipped. Refer to Door Window Regulator Handle Replacement .
  4. Remove the power window switch, if equipped. Refer to Front Side Door Window Switch Replacement .

  5. Object Number: 294620  Size: SH
  6. Remove the trim panel screws from the armrest. Carefully pry off the cover using a flat-bladed tool.
  7. Use the J 38778 in order to release the door trim panel retainers.
  8. Remove the door trim panel from the door.

Installation Procedure


    Object Number: 294620  Size: SH
  1. Install the door trim panel to the door.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the trim panel armrest screws to the armrest.
  4. Tighten
    Tighten the screws to 1.9 N·m (17 lb in).

  5. Position the cover and snap the cover into place.
  6. Install the power window switch, if equipped. Refer to Front Side Door Window Switch Replacement .
  7. Install the window regulator handle, if equipped. Refer to Door Window Regulator Handle Replacement .
  8. Install the inside door handle bezel. Refer to Door Inside Handle Bezel Replacement .
  9. Install the window weatherstrip. Refer to Rear Side Door Window Weatherstrip Replacement .

Rear Side Door Trim Panel Replacement Extended Cab P/U Only

Tools Required

J 38778 Trim Pad and Garnish Clip Remover

Removal Procedure


    Object Number: 294662  Size: SH
  1. Remove the bottom anchor bolt on the seat belt.
  2. Remove the trim cover of the shoulder belt opening.
  3. Using the J 38778 , remove the trim panel retainers from the rear side door.
  4. Feed the seat belt through the trim panel.

Installation Procedure


    Object Number: 294662  Size: SH
  1. Feed the seat belt through the trim panel.
  2. Install the trim panel to the rear side door.
  3. Install the trim cover of the shoulder belt opening.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the bottom anchor bolt on the front seat belt.
  6. Tighten
    Tighten the bolt to 70 N·m (52 lb ft).