Front Seat Back Replacement Bench Seat

1. Remove the seat from the vehicle. Refer to Bucket Seat Replacement or Bench Seat Replacement .
2. Remove the recliner assembly. Refer to Front Seat Recliner Replacement .
3. Remove the seat back pivot bolt.
4. Remove the seat back from the lower frame.

1. Install the seat back to the lower frame.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the seat back pivot bolt.

Tighten
Tighten the seat back pivot bolt to 47 N·m (35 lb ft).

3. Install the recliner assembly. Refer to Front Seat Recliner Replacement .
4. Install the seat to the vehicle. Refer to Bucket Seat Replacement or Bench Seat Replacement .

Front Seat Back Replacement Bucket Seat

1. Remove the seat from the vehicle. Refer to Bucket Seat Replacement .
2. Remove the seat back cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement .
3. Remove the seat cushion trim cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement .



4. Disconnect the electrical connector for the seat back recliner motor, if equipped.
5. Remove the bolts securing the seat back to the seat adjuster assembly.
6. Remove the seat back.

1. Install the seat back to the seat adjuster assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the bolts securing the seat back to the seat adjuster assembly.

Tighten
Tighten the seat back bolts to 24 N·m (18 lb ft).




3. Connect the electrical connector for the seat back recliner motor, if equipped.
4. Install the seat cushion trim cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement .
5. Install the seat back cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement .
6. Install the seat in the vehicle. Refer to Bucket Seat Replacement .