GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Blazer - 2WD 🢒 Body and Accessories 🢒 Body Rear End 🢒 Endgate Latch Replacement

Removal Procedure

    Object Number: 392980 Size: SH
  1. Open the endgate.
  2. Remove the endgate trim panel. Refer to Endgate Trim Panel Replacement .
  3. Remove the endgate latch rod from the endgate latch.
  4. Remove the bolts that retain the endgate latch to the endgate.
  5. Remove the endgate latch from the vehicle.

Installation Procedure

    Object Number: 392980 Size: SH
  1. Install the endgate latch to the vehicle.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolts that retain the endgate latch to the endgate.

    3. Tighten
    Tighten the bolts to 10 N·m (88 lb in).

  3. Install the endgate latch rod to the endgate latch.
  4. Install the endgate trim panel. Refer to Endgate Trim Panel Replacement .