Removal Procedure
- Remove the instrument panel accessory trim plate. Refer to
Instrument Panel Accessory Trim Plate Replacement.
- Remove the screws from the instrument panel cluster.
- Disconnect the electrical connector from the instrument panel cluster.
- Remove the instrument panel cluster from the instrument panel.
Installation Procedure
- Install the instrument panel cluster to the instrument panel.
- Connect the electrical connector to the instrument panel cluster.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the screws to instrument panel cluster.
Tighten
Tighten the screws to 1.9 N·m (17 lb in).
- Install the instrument panel accessory trim plate. Refer to
Instrument Panel Accessory Trim Plate Replacement.
- Refer to
Control Module References for programming and setup information.