Schematic Reference: Instrument Cluster Schematics

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Install a scan tool.
2. Turn the ignition ON, with the engine OFF.
3. Compare the scan tool Battery Voltage parameter in the BCM Data data list to the volt gage display.

Does the Battery Voltage parameter approximately match the volt gage display?

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Go to Step 3

Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 4

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2