- Install the cam plate to the side cam gear.
- Install the wave washer.
- Install the clutch plates.
Alternate the plates as shown.
- Install the thrust sleeve.
Press the thrust sleeve flush with the side gear disc splines.
- Install the guide clips to the clutch plates.
5.1. | Use grease in the clips in order to hold the clips in place on
the plates. |
5.2. | If the side cam gear or the side thrust sleeve has been replaced,
measure and record the overall length of the gear assembly from the front
of the gear to the back of the side thrust sleeve, including the side
gear thrust washer. |
5.3. | Compare the reading with the reading obtained earlier in this
section. |
5.4. | If the new reading is more than 0.0762 mm (0.003 in)
higher or lower than the original, select a thrust washer that will return
the reading closest to the original reading. |