GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Blazer - 2WD 🢒 Body 🢒 Doors 🢒 Door Inside Handle Bezel Replacement

Removal Procedure

    Object Number: 294583 Size: SH
  1. Remove the screw that retains the front inside door handle bezel to the door trim panel.

    2. Object Number: 294603 Size: SH
  2. Remove the screw that retains the rear inside door handle bezel to the door trim panel.
  3. Remove the inside door handle bezel from the door trim panel by sliding rearward.

Installation Procedure

    Object Number: 294603 Size: SH
  1. Route the inside door handle and the lock rod through the appropriate openings in the bezel.
  2. Align the lock rod to the door lock knob.
  3. Position the bezel and snap the bezel into place.
  4. Install the rear inside door handle bezel to the door trim panel.

    5. Object Number: 294583 Size: SH
  5. Install the front inside door bezel to the door trim panel.

    6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Insert the screw that retains the inside door handle bezel to the door trim panel.

    7. Tighten
    Tighten the screw to 1.9 N·m (17 lb in).