Schematic Reference: Exterior Lights Schematics

Connector End View Reference: Lighting Systems Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Verify that the tail, marker, and license lamps lamps are inoperative.

Do the tail, marker, and license lamps lamps operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Inspect the PARK LP fuse in the body relay block.

Is the fuse good?

Go to Step 4

Go to Step 5

Disconnect the headlamp switch and connect a fused jumper between the battery positive voltage circuit input terminal and the park lamps switch signal circuit output terminal at the headlamp switch connector.

Do the tail, marker, and license lamps illuminate?

Go to Step 8

Go to Step 6

Remove the park lamp relay and test for a short to ground in the following circuits. Refer to Circuit Testing in Wiring Systems:

Was a problem found?

Go to Step 7

Go to Step 9

Repair the open or high resistance in the following circuits. Refer to Wiring Repairs in Wiring Systems:

Is the repair complete?

Go to Step 10

--

Repair the short to ground in one of the following circuits. Refer to Wiring Repairs in Wiring Systems:

Is the repair complete?

Go to Step 10

--

Replace the headlamp switch. Refer to Headlamp Switch Replacement .

Is the repair complete?

Go to Step 10

--

Replace the park lamp relay. Refer to Relay Replacement in Wiring Systems.

Is the repair complete?

Go to Step 10

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3