Sunroof Window Replacement CF5

Important: The sunroof must be in the fully closed position prior to removing the glass panel.

1. Open the sunshade panel.



2. Remove the 4 screws (2) that retain the sunroof window (1) to the sunroof module assembly.
3. Remove the sunroof window from the top of the vehicle.

1. Position the sunroof window (1) to the vehicle.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the screws (2) that retain the sunroof window (1) to the sunroof module assembly.
3. Perform the following steps in order to adjust the sunroof window.

3.1.	Adjust the fit between the sunroof window and the roof opening.

The fit should be equal on both sides.

3.2.	Adjust the rear edge of the window slightly higher than the front edge in order to minimize wind noise.

Tighten
Tighten the sunroof window screws to 3 N·m (27 lb in).

4. Open and close the sunroof.
5. Inspect the fit of the sunroof window.