Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Driver Seat Schematics or Passenger Seat Schematics DEFINITION: This table assumes that all mechanical linkage and drivers are free from obstruction and not binding. This also assumes that all other directions are operational. | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Operate the power seat in the rear tilt position. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Did the test lamp illuminate? | Go to Step 4 | Go to Step 6 |
4 |
Did the test lamp illuminate? | Go to Step 5 | Go to Step 7 |
5 |
Did the test lamp illuminate in both directions? | Go to Step 9 | Go to Step 8 |
6 | Test the power seat motor rear vertical down control circuit for an open or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 8 |
7 | Test the power seat motor rear vertical up control circuit for an open or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 8 |
8 | Inspect the poor connections at the harness connector of the power seat switch. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 11 |
9 | Inspect the poor connections at the harness connector of the rear vertical motor. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 10 |
10 | Replace the rear vertical motor. Refer to Front Seat Adjuster Replacement . Did you complete the replacement? | Go to Step 12 | -- |
11 | Replace the power seat switch. Refer to Power Seat Switch Replacement in Wiring Systems. Did you compete the replacement? | Go to Step 12 | -- |
12 | Operate the system to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |