GM Service Manual Online
For 1990-2009 cars only

Cruise Control Cable Replacement LU3

Removal Procedure

    Notice: Do not remove the C-clip from the cruise control connector. The C-clip was not designed for removal. Damage may occur when removing.

    Important: The cruise control cable does not require mechanical adjusting after the replacement. The cruise control module internally adjusts the cable. Refer to Cruise Control Description and Operation for the complete operational details.


    Object Number: 567860  Size: SH
  1. Open the hood.

  2. Object Number: 567851  Size: SH
  3. Do not remove the adjuster screw from the end of the cruise control cable. No adjustment will be needed.

  4. Object Number: 580244  Size: SH
  5. Remove the cruise control cable from the throttle linkage.
  6. Use a suitable tool to lightly pry off the end of the cruise control cable from the stud on the throttle lever.


    Object Number: 580230  Size: SH
  7. Disconnect the cruise control cable from the round hole in the engine cable bracket.

  8. Object Number: 597198  Size: SH
  9. Disconnect the cruise control cable locator clip from the rectangular hole in the routing bracket.

  10. Object Number: 597101  Size: SH
  11. Remove the cruise control cable from the cruise control module housing.
  12. Important: Do not allow the cruise control ribbon (1) to retract into the module assembly.

  13. Disconnect the cruise control cable bead (2) from the end of the ribbon (1).
  14. Remove the cruise control cable from the vehicle.

Installation Procedure

  1. Install the cruise control cable to the vehicle.

  2. Object Number: 293672  Size: SH
  3. Remove all bends and twists from the cruise control module ribbon and cable, by rotating until removed.

  4. Object Number: 597101  Size: SH

    Important: 

       • Do not twist the cruise control module ribbon (1).
       • Pull the cruise control cable (2) to verify retention to the ribbon (1).

  5. Attach the cruise control cable bead (2) to the cruise control module ribbon (1).

  6. Object Number: 293695  Size: SH
  7. Check the orientation of the cruise control ribbon buckle to the cable end fitting.

  8. Object Number: 487408  Size: SH
  9. Slide the cruise control cable conduit over the ribbon.
  10. 5.1. Install the tangs to the cruise control module housing.
    5.2. Ensure that the tangs snap securely into place.

    Object Number: 580222  Size: SH
  11. Snap the cruise control cable engine-end fitting (2) over the stud (1) on the throttle cam lever.

  12. Object Number: 580230  Size: SH
  13. Connect the cruise control cable conduit fitting to the round hole in the engine cable bracket.
  14. Ensure that the tabs snap securely into the hole.


    Object Number: 597198  Size: SH
  15. Connect the cruise control cable locator clip to the rectangular hole in the routing bracket.
  16. 8.1. Route the cruise control cable above the accelerator cable.
    8.2. Ensure that the clip snaps securely into place.

    Object Number: 418780  Size: SH
  17. Connect the electrical connection to the cruise control servo module.
  18. Test the systems operation.
  19. Perform the Cruise Control System Functional Test. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
  20. Close hood.