Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
Caution: Do not strike or jolt the inflatable restraint sensing and diagnostic module
(SDM). Before applying power to the SDM, make sure that it is securely fastened with
the arrow facing toward the front of the vehicle. Failure to observe the correct
installation procedure could cause SIR deployment, personal injury, or unnecessary
SIR system repairs.
- Disable the SIR system. Refer to
SIR Disabling and Enabling and
SIR Disabling and Enabling.
- Remove the floor console, if equipped. Refer to
Front Floor Console Replacement.
- Cut an "X" in the carpet over the inflatable restraint sensing and diagnostic module (SDM).
- Fold the carpet back to expose the SDM.
- Remove the connector position assurance (CPA) (4) from the SDM harness connector (3).
- Disconnect the SDM harness connector (3) from the SDM (2).
- Remove the SDM mounting fasteners (1).
- Remove the SDM (2) from the vehicle.
Important: The following repair procedures should only be used in the event that the inflatable restraint sensing and diagnostic module (SDM) mounting studs and/or fasteners are damaged to the extent that the SDM may no longer be
properly mounted.
- Repair the fasteners using the following procedure:
9.1. | Remove the stripped nut and discard the nut. |
9.2. | Drill out the weld spots to the weld stud from the floor pan side, then remove and discard the stud. |
9.3. | Condition the floor panel attaching surface where the new stud is to be installed. |
9.4. | Install new weld stud GM P/N 115115602 and clamp the weld stud. |
9.5. | Migweld the stud at the drilled holes from above or below the floor pan (as required). |
9.6. | Apply body sealer GM P/N 9984248 around any exposed openings. |
9.7. | Install a new fastener GM P/N 11515933. |
Installation Procedure
- Remove any dirt, grease, or other impurities from the mounting surface.
- Install the SDM (2) horizontally to the vehicle.
- Point the arrow on the SDM toward the front of the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
- Install the SDM mounting fasteners (1).
Tighten
Tighten fasteners to 12 N·m (106 lb in).
- Install the SDM harness connector (3) to the SDM (2).
- Install the CPA (4) to the SDM harness connector (3).
- Tape the cut carpet to cover the SDM.
- Install the floor console, if equipped. Refer to
Front Floor Console Replacement.
Important: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform
the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly.
- Enable the SIR system. Refer to
SIR Disabling and Enabling and to
SIR Disabling and Enabling.
- Refer to
Control Module References for programming and setup information.