Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Lighting Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 | Verify that the hazard lamps are inoperative. Do the hazard lamps operate normally? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Inspect the HAZ LP fuse in the underhood fuse block. Is the fuse open? | -- | Go to Step 8 | Go to Step 4 |
4 | Using a test lamp from ground, backprobe connector C211 terminal A4. Does the test lamp illuminate? | -- | Go to Step 6 | Go to Step 5 |
5 | Locate and repair the open or high resistance in CKT 140 (ORN). Is the repair complete? | -- | Go to Step 11 | -- |
6 |
Does the test lamp illuminate? | -- | Go to Step 8 | Go to Step 7 |
7 | Replace the multifunction switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Standard or Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt. Is the repair complete? | -- | Go to Step 11 | -- |
8 | Inspect for open, high resistance or short to ground in CKT 1696 (GRY) or short to ground in CKT 140 (ORN). Was a problem found? | -- | Go to Step 9 | Go to Step 10 |
9 | Locate and repair the open, high resistance or short to ground in CKT 1696 (GRY) or short to ground CKT 140 (ORN). Is the repair complete? | -- | Go to Step 11 | -- |
10 | Replace the turn signal lamp flasher. Is the repair complete? | -- | Go to Step 11 | -- |
11 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 3 |
