GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 443596  Size: SH
  1. Mark the wiper park position on the windshield with a suitable non-permanent marker.
  2. Remove the cover from the wiper arm nut.
  3. Remove the wiper arm retaining nut.

  4. Object Number: 443598  Size: SH
  5. Remove the wiper arm from the wiper transmission drive shaft.

Installation Procedure

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 443598  Size: SH
  1. Install the wiper arm onto the wiper transmission drive shaft.
  2. 1.1. Align the wiper arm with the marks made on the windshield.
    1.2. Push the wiper arm down onto the wiper transmission drive shaft completely.

    Object Number: 443596  Size: SH
  3. Install the retaining nut onto the wiper transmission drive shaft and the wiper arm.
  4. Tighten
    Tighten the nut to 23 N·m (17 lb ft)

  5. Install the cover on the wiper arm nut.