With the wiper switch in DELAY (pulse), battery voltage is applied to the wiper motor at terminal C through CKT 143. Voltage is also applied to terminal A through CKT 113 and terminal E through CKT 112.

The length of delay time between sweeps is controlled by the variable-pulse delay resistor. The delay is adjustable from 1-22 seconds, nominally.

In the LO position of the wiper switch, battery voltage is applied to the wiper motor connector at terminal C through CKT 143, terminal E through CKT 112, and terminal A through CKT 113.

The wiper motor module supplies power to the wiper motor which runs continuously through the low-speed relay.

In the HI position of the wiper switch, battery voltage is applied at terminal C, D, and E of the wiper motor through CKT 143, 92, and 112. Voltage is also applied to terminal A through CKT 113.

When turned OFF from any position, the wipers complete the last sweep and park. When the wiper switch is in OFF, the wiper motor has battery voltage applied to terminal C only from CKT 143. The wiper motor continues to run until the park switch opens.

Washer Operation

When the washer switch is turned to ON, the battery voltage is applied to terminal A of the wiper motor through CKT 113. The washer switch also applies voltage to the washer pump through CKT 228. The wiper motor has voltage applied through the low-speed relay and operates at low speed for 2-4 wipes.

When the washer switch is held on, the wiper motor module will keep the washer pump on only as long as the washer switch is held on.

If the wipers had been in DELAY, LO, or HI, they would return to that operation after the wash cycle. If in the OFF position, they then return to park position after 2-4 wipes.

The circuit operation in the MIST position is the same as that of low-speed.