Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement for Chevrolet Blazer - 4WD 2003

Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement Pickup

1. Open the endgate or liftgate.



2. Remove the screws that retain the tail lamp assembly to the vehicle.
3. Rotate the bulb sockets 1/4 turn counter-clockwise in order to remove the bulb sockets from the tail lamp assembly.
4. Remove the bulbs from the sockets by pulling out the bulbs.

1. Install the bulbs into the sockets.
2. Install the bulb sockets to the tail lamp assembly by rotating the sockets 1/4 turn clockwise.



3. Install the tail lamp assembly to the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the screws that retain the tail lamp assembly to the vehicle.

Tighten
Tighten the screws to 1.9 N·m (17 lb in).

Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement Utility

1. Open the endgate or liftgate.



2. Remove the screws that retain the tail lamp assembly to the vehicle.
3. Rotate the bulb sockets 1/4 turn counterclockwise in order to remove the bulb sockets from the tail lamp assembly.
4. Remove the bulbs from the sockets.

1. Install the bulbs into the sockets.
2. Install the bulb sockets to the tail lamp assembly by rotating the sockets 1/4 turn clockwise.



3. Install the tail lamp assembly to the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the screws that retain the tail lamp assembly to the vehicle.

Tighten
Tighten the screws to 1.9 N·m (17 lb in).

5. Close the endgate or liftgate.