Battery Positive Cable Replacement 4.3L

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Disconnect the positive battery cable from the battery.



3. Remove the bolt retaining the positive battery cable to the underhood fuse block.



4. Remove the nut retaining the positive battery cable to the generator.
5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



6. Remove the nut retaining the positive battery cable to the starter.
7. Remove the positive battery cable bolt from the engine.
8. Remove the battery positive cable.

1. Install the positive battery cable to the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the positive battery cable nut to the engine.

Tighten
Tighten the positive battery cable nut to 6 N·m (80 lb in).

3. Install the nut retaining the positive battery cable to the starter.

Tighten
Tighten the positive battery cable nut to 9 N·m (80 lb in).

4. Lower the vehicle.



5. Install the nut retaining the positive battery cable to the generator.

Tighten
Tighten the positive battery cable nut to 17 N·m (13 lb ft).




6. Install the nut retaining the positive battery cable to the underhood fuse block.

Tighten
Tighten the positive battery cable nut to 10 N·m (89 lb in).

7. Connect the positive battery cable to the battery.

Tighten
Tighten the positive terminal bolt to 14 N·m (11 lb ft).

8. Connect the negative battery cable to the battery.