GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 42371 Clutch Line Release Tool

Removal Procedure


    Object Number: 449286  Size: SH
  1. Remove the master cylinder rod from the clutch pedal.

  2. Object Number: 449289  Size: SH
  3. Turn the master cylinder 45 degrees clockwise to unlock the master cylinder.
  4. Disconnect the wiring harness from the clutch master cylinder start switch.

  5. Object Number: 449284  Size: SH
  6. Remove the clips securing the clutch line to the dash panel and heat shield.
  7. Remove the clutch master cylinder from the dash panel.
  8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

  9. Object Number: 416721  Size: SH
  10. Using the J 42371 remove the clutch line from the concentric slave cylinder.
  11. Lower the vehicle.
  12. Remove the clutch master cylinder.

Installation Procedure


    Object Number: 416721  Size: SH
  1. Install the clutch master cylinder.
  2. Raise the vehicle.
  3. Pull back on the connector sleeve and connect the clutch line to the concentric slave cylinder.
  4. Lower the vehicle.

  5. Object Number: 449284  Size: SH
  6. Install the clips securing the clutch line to the dash panel and heat shield.

  7. Object Number: 449289  Size: SH
  8. Position the clutch master cylinder into the cowl panel hole.
  9. Turn the master cylinder 45 degrees counterclockwise to lock the master cylinder.
  10. Connect the wiring harness to the clutch master cylinder start switch.

  11. Object Number: 449286  Size: SH
  12. Connect the master cylinder rod to the clutch pedal.
  13. Bleed the clutch. Refer to Hydraulic Clutch Bleeding .