GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Blazer - 4WD - RHD 🢒 Steering 🢒 Steering Wheel and Column 🢒 Ignition and Start Switch Replacement

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.


    Object Number: 385252 Size: SH
  1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
  2. Remove the lower steering column trim cover from the steering column. Refer to Steering Column Trim Covers Replacement .
  3. Disconnect the ignition switch electrical connector.
  4. Remove the ignition switch mounting screws.
  5. Remove the ignition switch from the vehicle.

Installation Procedure

    Object Number: 385252 Size: SH
  1. Install the ignition switch to the vehicle.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the ignition switch mounting screws.

    3. Tighten
    Tighten the screws to 1.5 N·m (13 lb in).

  3. Connect the ignition switch electrical connector.
  4. Install the lower steering column trim cover. Refer to Steering Column Trim Covers Replacement .
  5. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.