Important: Replace the CD changer and the plastic bin as an assembly. Removing and installing the screws that attach the CD changer to the plastic bin may cause the CD changer to perform improperly.

1. Open the armrest (5) on the center console to reveal the remote CD changer assembly.
2. Remove the 2  front screws (1) and the rear screw (3) that attach the CD changer assembly to the center console.
3. Pull the CD changer assembly vertically out of the center console.
4. Disconnect the electrical connector to the CD changer (4).

1. Attach the electrical connector to the CD changer.
2. Install the CD changer assembly into the center console.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the front CD changer assembly retaining screws (1).

Tighten
Tighten the front CD changer assembly retaining screws to 1.9 N·m (17 lb ft).

4. Install the rear CD changer assembly retaining screw.

Tighten
Tighten the rear CD changer assembly retaining screw to 2.5 N·m (22 lb ft).

5. Close the center armrest.