For 1990-2009 cars only
Removal Procedure
- Open the door.
- Remove the drip molding (3).
Installation Procedure
- Clean the area where the molding is to be mounted. Use a general purpose adhesive remover.
- Clean the affected body area with wax and grease remover, and wipe with isopropyl alcohol.
- Dry the area thoroughly.
- Ensure the body area is at a temperature range of 21-41°C (80-105°F).
- Ensure that the molding is at a temperature range of 21-41°C (80-105°F).
- Install end of seal beginning at the upper rear corner (4) of front side door opening frame, towards the windshield reveal molding flange (1) removing the tape backing as seal is applied.
- When seal is in position use a roller to firmly attach the tape to the entire contact surface.
Important: Apply the drip molding in an environment free of dust or dirt that could come in contact with the sticky backing (2) and prevent proper adhesion.
