Removal Procedure
- Open the sunshade panel.
- Remove the 4 screws (2) that retain the sunroof window (1) to the sunroof module assembly.
- Remove the sunroof window from the top of the vehicle.
Important: The sunroof must be in the fully closed position prior to removing the glass panel.
Installation Procedure
- Position the sunroof window (1) to the vehicle.
- Install the screws (2) that retain the sunroof window (1) to the sunroof module assembly.
- Perform the following steps in order to adjust the sunroof window.
- Open and close the sunroof.
- Inspect the fit of the sunroof window.
| 3.1. | Adjust the fit between the sunroof window and the roof opening. |
The fit should be equal on both sides.
| 3.2. | Adjust the rear edge of the window slightly higher than the front edge in order to minimize wind noise. |
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the sunroof window screws to 3 N·m (27 lb in).
