GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Blazer - 4WD - RHD 🢒 Body and Accessories 🢒 Body Rear End 🢒 Endgate Lock Striker Replacement

Removal Procedure

    Object Number: 594673 Size: SH

    Important: Do not remove both endgate striker bolts at the same time in order to prevent the striker backing plate from falling into the body.

  1. Remove the lower striker bolt.
  2. Loosen the upper striker bolt in order to rotate the striker and the spacer (if equipped) away from the lower bolt hole.
  3. Install the lower striker bolt.
  4. Tighten the lower striker bolt in order to hold the striker backing plate in place.
  5. Remove the upper striker bolt.
  6. Remove the spacer (if equipped).
  7. Remove the striker.

Installation Procedure

    Object Number: 594673 Size: SH
  1. Install the striker.
  2. Install the spacer (if equipped).
  3. Install the upper striker bolt.

    4. Rotate the lower striker bolt until the upper threaded hole is properly aligned in order to ensure that the backing plate is in the correct position.

  4. Remove the lower bolt.
  5. Rotate the striker and the spacer (if equipped) in order to align the lower threaded hole in the striker backing plate.

    6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Install the lower striker bolt.

    7. Tighten
    Tighten the bolts to 22 N·m (16 lb ft).