Tools Required

J 34940 Rivet Gun

1. Open the endgate.
2. Remove the screws that retain the inside handle to the endgate handle assembly.
3. Drill out the rivets that retain the endgate handle assembly to the endgate.
4. Remove the endgate handle assembly from the endgate.

1. Position the endgate handle assembly on the endgate.
2. Install the endgate handle assembly to the endgate with two rivets using a J 34940 .

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the screws that retain the inside handle to the endgate handle assembly.

Tighten
Tighten the screws to 2.8 N·m (25 lb in).