GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Blazer - 4WD - RHD 🢒 General Information 🢒 General Information 🢒 Stabilizer Shaft Link Replacement

Removal Procedure

    Object Number: 3640 Size: SH
  1. Raise and suitably support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the stabilizer shaft link bolt.
  3. Remove the stabilizer shaft link insulator, spacer, and upper retainer.
  4. Inspect all of the parts for wear or damage.

Installation Procedure

    Object Number: 3640 Size: SH
  1. Install the stabilizer shaft link insulator to the stabilizer shaft link bolt.
  2. Install the stabilizer shaft link bolt through the stabilizer shaft.
  3. Install the stabilizer shaft link spacer.
  4. Install the stabilizer shaft link bolt through the lower control arm with the parts stacked properly.
  5. Install the stabilizer shaft link insulator.
  6. Install the stabilizer shaft link upper retainer.

    7. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Tighten the stabilizer shaft link bolt.

    8. Tighten
    Tighten the stabilizer shaft link bolt to 15 N·m (11 lb ft).

  8. Lower the vehicle.